DynaFlex® is excited to announce the availability of Custom Direct Printed Metal Bands. This state-of-the-art technology will dramatically decrease patient chair time while ensuring precise fit and comfort.
-
No Need For Separators
-
No Band Fitting Appointment
-
Fast & Easy Cementation
-
Streamline & Sleek Design
-
316L Medical Grade Stainless Steel
Available On Any Appliance Requiring Bands. Simply “Check” 3D Custom Printed Bands On Your DynaFusion® Rx!
RPE’s and Expansion Appliances
Transpalatal Bar / Lingual Holding Arch
MAX 2000
Hanks Telescoping Herbst
Bonding:
Follow Standard Band/Crown Appliance Bonding set up. The properties of this metal (316L) are similar to current bands/crowns therefore the bonding method is the same. Many different Glass ionomer or light-cured adhesives will work for bonding, however, we recommend using Reliance Ultra Band-Lok Light Cure Adhesive (DynaFlex® Item #18-UBBPP).
Recommended Steps:
Step 1: Ensure appliance fits patient properly prior too bonding.
Step 2: For stronger bond strength; micro-etch interior of band or wings.
Step 3: It is recommended to acid etch each tooth that will have bonding adhesive.
Step 4: Isolate and prep teeth in normal procedure.
Step 5: Use of bonding booster is recommended but is optional.
Step 6: Small ring of adhesive is placed around the occlusal surface of the crown/band and other surfaces touching teeth per design of appliance.
Step 7: Seat appliance. Use cotton roll or other seating accessory to fully seat appliance if necessary.
Step 8: Clean up flash.
Step 9: Light cure as needed per adhesive instructions.
Debonding:
Debond is similar to traditional band/crown debonding technique.
Recommended Steps:
Step 1: Use band/crown removal instrument (DynaFlex® Item #M-D444). Option: Slit the buccal side of crown with a bur for easy removal.
Step 2: Remove remaining adhesive and properly clean all tooth surfaces where bonding occurred.
How To Order In DynaFusion®
STEP 1: In DynaFusion®, scroll down to Select Crowns Or Bands To Be Seated.
STEP 2: Select DynaFlex Custom Direct Printed Bands.
STEP 3: Select the correct upper & lower tooth.